ADAPTERS
Adapter for printing on Petri dish
Adapter for printing on Petri dish
Glass Plate
COMPONENTS
UV light curing system
Interchangeable printing head. The light curing system has an intensity of 14,000 mW/cm2 and a wavelength of 365nm
Each component is carefully designed to be able to adapt to the requirements of the scientific-academic community in order to offer a wide range of possibilities in the field of research.
Infrared light curing system
Infrared light source with direct incidence on the extruded material with control.
Each component is carefully designed to be able to adapt to the requirements of the scientific-academic community in order to offer infinite possibilities in the field of research.
Bi-component syringe
Interchangeable printing head. Mixing occurs at the tip of the syringe.
Each component is carefully designed to adapt to the requirements of the scientific-academic community in order to offer infinite possibilities in the field of the investigation.
Metal syringe
Interchangeable printing head. Heating thanks to the electrical system and uniform heat distribution with electronic control of the created filament.
This syringe has been specially designed for working at high temperatures until 250ºC.
Each component is carefully designed to be able to adapt to the requirements of the scientific-academic community in order to offer a wide range of possibilities in the field of research.
Refrigerated Syringe
Interchangeable printing head. The temperature range depends on the refrigeration installed.
Pellets extruder system and filament winder
Creation of filament from the material in pellet format with a winding system to facilitate storage of the created filament.
Each component is carefully designed to be able to adapt to the requirements of the scientific-academic community in order to offer infinite possibilities in the field of research.
Heated syringe
Interchangeable printing head. Heating thanks to electrical system and uniform heat distribution with electronic control of the created filament
Each component is carefully designed to be able to adapt to the requirements of the scientific-academic community in order to offer a wide range of possibilities in the field of research.
Pellets extruder system and filament winder
Creation of filament from the material in pellet format with a winding system to facilitate storage of the created filament.
Each component is carefully designed to be able to adapt to the requirements of the scientific-academic community in order to offer infinite possibilities in the field of research.